Rain Gutter Repair – An Expert Guide To Fixing Common Problems

Gutter repair is often necessary when gutters haven’t been cleaned in a long time.

Heavy-duty expanded metal gutter leaf screens are the best leaf protection and are excellent at stopping leaves and twigs from entering your gutters. These screens make it easy to inspect your gutters.

Once in a while, debris, such as pine needles, may need to be manually cleaned off.

The gutter should be adjusted to remove any high or low spots preventing water flow toward the downspout.

If any single length of the gutter is more than 30′ long, it should be installed to drain in both directions from the center and have downspouts installed on each end.

Gutters that are installed with spikes and ferrules will become loose over time.

The expansion and contraction of the gutters due to temperature changes between summer and winter will loosen the spikes or (nails). You may be familiar with these large nails that must be pounded every year.

Gutters that are not adequately secured to the house, i.e., improper gutter screws or channels attached to rotten wood, will eventually not support their weight.

Downspout Maintenance

If you have a clogged downspout, run a garden hose down from the top, turn the water on full blast, and hopefully, the clog will be cleared.

If all this fails to remove the clog, the downspout will have to be removed and removed to find the clog. I have seen many things on downspouts, like toys and golf balls.

Inspect downspouts and lower elbows for loose connections or damage. The lower downspout elbow occasionally becomes damaged by lawn equipment or animals.

Always disconnect your downspouts from underground drain lines before flushing them out.

Water should be discharged from the downspout at least 5 feet from the foundation using splash blocks, downspout extensions, or underground drainage.

This would also be an excellent time to check the splash blocks. They need to be re-leveled once in a while. Over time, they tend to sink into the ground. Dig them out, repack the dirt, and lay them down.

Also, the water runoff path from the blocks should be clear of obstructions like leaves or twigs to keep the water flowing away from your foundation.

The real secret to painting galvanized steel is the surface preparation of the galvanized surface.

Paint peeling is typical in galvanized steel gutters. The problem usually exists because unsuitable paint was used for the original coat on the gutters and downspouts.

Gutter Damage From Ice And Snow

Another gutter repair problem, much more common in the northern United States, is damage from snow and ice. An ice dam will form when melted snow refreezes at the roof edges.

However, gutters help concentrate ice and water in vulnerable areas.

Gutters installed on homes or buildings with metal roofs are especially vulnerable to damage from snow accumulation.

As the temperature warms up, large chunks of snow can slide off the roof, resulting in sometimes severe gutter damage.

Check For Signs Of A Problem

Observing your gutters during heavy rain is the best way to see if you need any gutter repairs. Make sure all of your downspouts are flowing correctly. Check to see if water is overflowing from the top of the channel.

If your gutters are filling up faster than they are draining out, you either have a blockage or insufficient downspouts.

Check for water leaking from behind the gutter; this would indicate that the back of the channels was not installed under the drip edge flange.

You also need to look for leaks at the corners and end caps to see if they are adequately sealed.

If you discover bent gutter hangers that are tightly screwed to the structure, it indicates excessive weight in the gutter.

Most likely from ice, snow, or a major clog, allowing the gutter to hold water.

Neglecting rain gutter repair will result in costly soffit and fascia repairs. Peeling paint or wood rot indicates that water is overflowing the gutters in that area.

Splash guards must be installed inside corners or anywhere two roof lines meet to form a valley. These splash guards keep the water from overshooting your gutter at the roof valley.

Gutter Repair Safety

If you decide to take on the job of cleaning your gutters, please follow these safety rules:

Be careful! Keep ladders, tools, and yourself a minimum of ten feet away from overhead power lines. Plan your gutter cleaning when someone else is at home, or let a neighbor know what you are doing.

A step ladder requires level ground support on all four side rails. Ensure your step ladder is fully open and the spreaders are locked.

Use ladder accessories like stand-offs and leg levelers on extension ladders.

Never place your ladder on any other unstable base to obtain additional height.

While performing gutter repairs, you should always wear gloves to prevent being cut by sharp metal edges. Also, moist and rotten debris are good places for bacteria to grow.

When you disrupt the gutter debris, you also disturb many dust particles and mold spores.

Put on a dust mask if you have an allergy.